A black bending tool plate with increment marks from 30 on the left, 0 in the middle, and 30 on the right. There are three tools placed on the plate (from left to right): a stylus, a 5/64 inch hex driver, and a 0.035 inch hex driver.
A diagram depicting the different components of the Bending Tool and accessories.
The Bending Tool placed horizontally, with the stylus facing about a 45 degree angle upwards.
The Bending Tool from above, with the stylus placed on top facing the 10 increment mark on the right.
A 2-Piece Offset Guide Post before a bend, and after a bend on the right side.

Bending Tool with 3.0 Stylus

$500.00
SKU: 2881
Shipping calculated at checkout.

Advantages, Protocol, and Purpose: Bending Tool Protocol

The Bending Tool is designed for making single or multiple bends to Guide Right™ 2-Piece Guide Posts to accomplish angle corrections determined by an evaluation with a cone beam X-ray.

Pair with:

Relevant Presentations:

- 2 GRAFTS & REPLACEMENT OF LOWER INCISOR
- FABRICATION OF MAXILLARY DENTURE GUIDE
- CASE FOR CO-AXIS ANGLED IMPLANTS
- IMMEDIATE PLACEMENT • IMMEDIATE LOAD
- STEPS TO MAKING A SURGICAL GUIDE
- USE OF 2-PIECE GUIDE POST WITH ANGLE & LINEAR CORRECTIONS

A black bending tool plate with increment marks from 30 on the left, 0 in the middle, and 30 on the right. There are three tools placed on the plate (from left to right): a stylus, a 5/64 inch hex driver, and a 0.035 inch hex driver.
A diagram depicting the different components of the Bending Tool and accessories.
The Bending Tool placed horizontally, with the stylus facing about a 45 degree angle upwards.
The Bending Tool from above, with the stylus placed on top facing the 10 increment mark on the right.
A 2-Piece Offset Guide Post before a bend, and after a bend on the right side.

You might also like…